Vertical Acid Resistant Collection Pit Electric Slurry Pump

Description:

Vertical Sump Pumps are designed for every other tank, pit or hole-in-the-ground slurry handling situation, ZP pumps are available in various standard lengths to suit common sump depths, for very deep sumps or where high shaft speeds limit the length of the pump, a suction extension pipe can be fitted to the bottom inlet to extend the depth of the pump by up to 2 meters.

Vertical Slurry Pump is available in a wide range of popular sizes to suit most pumping applications. Thousands of these pumps are proving their reliability and efficiency worldwide in Minerals processing, Coal preparation, Chemical processing, Effluent handling, Sand and gravel and almost every other tank, pit or hole-in-the ground slurry handling situation.

Structure features:

1. Cantilever design without submerged bearings or shaft seals;

2. Wet components are available in A05 high chrome alloy and elastomer (rubber);

3. The screened inlets and large impeller passages reduce the risk of blockages;

4. Available in a pre-fabricated conical sump with quick clean facilities;

5. Replaceable strainers allows for easy maintenance;

6. Simple installation and easy maintenance.

7. Anti-wear, anti-corrosion, which let the pumps service more longer;

8. No priming required;

Design features:

Less wear, less corrosion

Wetted components are available in a wide range of alloys and elastomers. Zidong selects the optimum combination of materials for maximum resistance to wear in virtually any industrial application, including those demanding both abrasion and corrosion resistance, and where larger particles or high density slurries are encountered.

• Abrasion resistant Ultra chrome® A05 alloy.

• Abrasion/corrosion-resistant Hyper chrome® A49 alloy.

• Corrosion-resistant stainless steels.

• Natural and synthetic elastomer.

No submerged bearing failures

The robust cantilever shaft avoids the need for lower submerged bearings which are often the source of premature bearing failure.

• Heavy duty roller bearings, above mounting plate.

• No submerged bearings.

• Labyrinth/flinger bearing protection.

• Rigid, large diameter shaft.

No shaft sealing problems

The vertical cantilever design requires no shaft seal.

No priming required.

The top and bottom inlet design is ideally suited for “snore” conditions.

Less risk of blocking

The screened inlets and large impeller passages reduce the risk of blockages.

Zero ancillary water costs

The vertical cantilever design with no gland or submerged bearings avoids the need for expensive gland or bearing flushing water